Privacy Policy | Terms of Service Google is a trademark of Google LLC. I’ll post it here if people want to try it out . Specific operations for obtaining the gateway KEY are as follows: 1.Add Hubs on Aqara Home App, then login AIOT Opencloud Website and enter Console. Aqara Hub dev mode Hi all, I've noticed Aqara recently release a new firmware update (1.6.0_009) but I'm trying for a long time to get the developer keys and enable dev mode. Would be nice to get it all in one place though and then start tying things into the sensors.In the app, go to the about page as described elsewhere, and tap in the blank area. Hub.
Aqara Hub adopts one body shell design and uses NXP i.MX6 CPU, 256M DRAM, 256M flash, and an All tutorials seems to read out the developer key on an older version of the mi app. © 2019 Lumi United Technology Co., Ltd. All rights reserved. With the Wireless Remote Switch, set your own night mode and turn off all the lights with a click of the button.Link the Smart Plug with a humidifier to improve indoor humidity. I succesfully have added it to the Mi Home App but I can‘t find the section for read out the developer key. Does anyone solved this already or isn‘t it working with v3 of the hub? Worked for me last week with the iOS app.Same issue with the current XiamoiHome-iOS-App (V4.19.1)When I click on the three dots in the upper right corner, I don’t get “about” - it will show immediately the “Settings”-page like this:Specific operations for obtaining the gateway KEY are as follows:The specific operation to obtain the gateway KEY is as follows:Note: Currently, only the “Upgraded Air Conditioning Companion” supports the LAN communication protocol function.I have one and I have no luck at all in getting into developer mode yet.Really wish I could so I could tie this into my OH setup but so far no luck.Hmm, then maybe you should buy one of the Xiaomi v3 gateways so you can integrate your devices in, while its still possible to buy them.It requires a little tinkering but will allow you to discard the gateway altogether. If a door or window is opened, the Hub will sound an alarm and send a notification to your phone.
I have just ordered the bits to try it out. With the Water Leak Sensor, when a leak is detected, the Hub will sound an alarm and send a notification to your phone.With the Aqara Home app (iOS or Android), you can control your home from almost anywhere at any time. Connecting via Zigbee protocol, Aqara* Up to 32 Aqara smart accessories can be connected to the Hub.You can use Home app to control the Hub and its connected accessories. Apple Home app (iOS 10.3 or later), Aqara Home app (Android 5.0 or later, iOS 10.3 or later)Aqara Hub, Smart Plug, Wireless Mini Switch, Wireless Remote Switch (Single Rocker), Wireless Remote Switch (Double Rocker), Door and Window Sensor, Motion Sensor, Temperature and Humidity Sensor, Vibration Sensor, Water Leak Sensor, Curtain Controller, Wall Switch, LED Light Bulb (Tunable White)Aqara Hub is a control center for an entire smart home. With a press of the Wireless Mini Switch, the Hub plays your preferred ringtone.With the Door and Window Sensor, you can turn on alarm mode when you leave the house or when you are asleep. I do know that the older Mi Gateways have the developer mode, and there are EU versions of those, but they’re not compatible with HomeKit out of the box like the Aqara or new Mi Gateways are. Sounds quite straightforward to get the developer key, however I don’t have any Aqara hub/gateway to test on. Aqara Hub, Smart Plug, Wireless Mini Switch, Wireless Remote Switch (Single Rocker), Wireless Remote Switch (Double Rocker), Door and Window Sensor, ... you can turn on alarm mode when you leave the house or when you are asleep. If a door or window is opened, the Hub will sound an alarm and send a notification to your phone.